Call in and inform Yard-Guy of plans to hump over well in advance, prepare to pig out
Reduce RPM on Main to idle(Continiously monitor flow if below 400gal/min STOP DRIVING
Start Air-Compressor
Slowly Reduce RPMs on Boosters as In-Pressure allows(not allowing boosters to raise above 5 in-Pressure)
(If in-Pressure goes above 5 on Boosters, Increase RPMS on boosters slowly)
(If in-Pressure on boosters goes above 20, Click Here for Critical In Pressure Steps
Follow the drag-line to crossroad slowly
Once Flow reaches below 400gal/min STOP, Turn on Aircompressor when yard guy notifies "The pig is in", and wait for flow to Increase to above 400gal/min before slowly starting to drive
Monitor Flow Carefully, when flow reaches 1000gal/min open pig valve
Drive slowly along hose and wait for pig to fly out
Inform yard guy, "The Pig is out"
Close Pig Valve
Stop and retrieve Pig
Drive straight(80% distance to opposite corner of square(If hose had slack go further, if hose was short slightly reduce distance to corner))
Now able to drive over Drag-hose with disks on applicator RAISED)
Turn back towards triangle starting point side
Follow hose to intersection
Drive 50% distance to start of crossover corner
Turn back towards triangle starting point side
Follow hose to intersection
Drive 30% distance past intersection to far corner
Turn back on triangle starting point side
Drive to intersection following hose
Turn to square starting point corner
Turn Towards Target border-line
Stop, wait for Yard-Guy to attach reel to hose
Proceed to Target Corner at a slow pace when Yard-Guy notifies that he is hooked onto pump-line
Turn Towards Target triangle when Corner is Reached
Turn off Air-Compressor, and stop(Only when flow is below 400gal/min)